What we repair
Common garage door problems in SeaTac homes
If your door is not working the way it should, one of these is usually the reason. SeaTac homeowners call us for broken garage door repair, spring and cable work, opener repair and general garage door service. Tell us what you are seeing and we will explain what is likely involved before anyone is dispatched.
Broken garage door springs
A sharp bang from the garage and a door that suddenly will not lift usually means a torsion or extension spring has snapped. Springs carry the weight of the door, so the opener cannot do the job alone.
What we do: We check spring type, size and door weight, then replace with springs matched to your door.
Damaged or frayed cables
Cables pull the door up evenly on both sides. Once a cable frays or snaps, the door hangs crooked and can drop or bind — continuing to run the opener makes it worse.
What we do: We inspect both cables and the drums, and replace them as a matched pair.
Door off its tracks
A door that has jumped the track is a safety issue, not just an inconvenience. It can fall, and it will not travel properly until it is realigned.
What we do: We realign the door, check the track for bends and replace damaged rollers or hinges.
Malfunctioning openers
Motor runs but the door does not move, the door reverses straight away, remotes will not sync, or the unit is dead after a power surge. Opener faults are often a worn gear, a logic board, or a safety sensor out of alignment.
What we do: We diagnose the opener and tell you whether a repair or a replacement is the better value.
Worn rollers and hinges
Worn or cracked rollers make the door drag, rattle and run rough. Left alone, that extra friction wears the rest of the hardware and shortens the life of your opener.
What we do: We replace worn rollers and hinges and adjust the door so it runs quietly again.
Noisy or stuck doors
Grinding, squealing or a door that stops halfway is usually binding, dry hardware, or a door that is out of balance. A properly balanced door opens with little effort by hand.
What we do: We lubricate and balance the system, then test a full open and close cycle with you there.